Tay Cầm Điều Khiển Chơi Game Nintendo Switch 3 3 6-axis Gyro

The wireless controller is compatible with the Switch console.
No need to install driver, can use after connecting through code matching.
Use Bluetooth connect to the console,stable connection signal.
Support gyroscope axis function and dual motor vibration function. No NFC function.

Buttons:
HOME button: Power on the Switch console or execute commands from the console.
D-Pad: up, down, left and right. It can be easily operated in eight directions.
Function control buttons: A, B, X, Y. Perfect button design, sensitive and quick finger operation.
Left joystick and right joystick: Neoteric 3D joystick can be accurately operated in 360°.
Function buttons: LB, RB, LT, RT. Trigger-type shoulder keys perform quick response functions.
VIB button: Take a screenshot and save it.
TURBO button: Turbo plus any button to achieve burst function
Reset button: Short press the reset button to disconnect the controller from the console.

Pair with Switch host:
Step 1: Go to Settings→Handle and Sensor→Change the grip/sequence of the handle.
Step 2: Press and hold the "Y+HOME" key combination, and then the 4 indicator lights will flash in turn. Wait a few seconds, the controller will pair with your host successfully.
Back to connect:
Press and hold the "HOME" button to reconnect to your Switch console.
power supply:
Press and hold the "HOME" button of the controller for 5 seconds to power off the controller.

Burst:
Burst button: X/Y/A/B/L/R/ZL/ZR/L3/R3
Burst setting: Press and hold one of the above buttons, then press the "T key to activate the burst function. Press the two buttons again to clear the burst function.
vibration:
Hold down the "T" button and "D-pad" to the left to increase the vibration intensity.
Press and hold the "T" button and the "D-pad" to the right to decrease the vibration intensity.

Reset:
Poke a small hole (reset button) on the back of the handle with a toothpick or needle to reset your handle.
Calibrate the gyroscope sensor/joystick:
(You need to calibrate the gyroscope when the character/view automatically moves. When the right stick cannot be used normally, you need to calibrate the stick.) Calibrate the gyroscope sensor: Settings → Handle and sensor → Calibrate the gyroscope sensor → follow Instruct to calibrate.
Calibrate the joystick: Settings→Handle and sensor→Calibrate the joystick→calibrate according to the instructions.
Connect to the computer:
The controller can only be used as a wired controller on the PC. Use the USB-C cable to connect the controller to the PC. ZL/ZR button supports analog quantity.
Default mode: X-Input
D-Input: Press and hold the "Capture" button until LED2 lights up to switch to D-Input- mode
Turn on/off the controller LED breathing light:
Press and hold the "T button and D-pad "up" button to turn on/off the LED breathing light.
parameter:
Battery: 600mAh
Pairing time: ≤10s
Connection time: ≤5s
Charger: 4 LED lights flashing
Fully charged: lights off
Fully battery can work about 15 hour
Charging ti