Súng hút thiếc đa năng tiện lợi

Product characteristics:
The 842a electric dual-use tin suction device has the characteristics of exterior appearance, novel structure, convenient use of tin suction cleanness. it can be used to easily remove the elements to be changed from the circuit board without damaging the elements and circuit board.The advantages of replacing the product circuit, multi-foot switch and so on are more prominent.This tin suction device can be used as a general electric soldering iron. it is a necessary tool for defense, scientific research, communication, aerospace, computer, radio, television, electronic maintenance professionals and radio lovers.


Method of use:

I. tin suction using mu rub rub 220v-50hz, power 30w
Ii. power supply, preheating 3-5 minutes
Push the piston handle down and hold it. the front end of the solder soldering iron nozzle is aligned to the solder point where the element is to be removed. when the solder melts, press the control button and the solder is sucked into the cylinder
Iv. tin suction device equipped with two different diameter suction nozzles, which can be selected according to the thickness of the element lead line
V. the same operation as the use of electric soldering iron when welding
When removing the cylinder, press the upper end of the cylinder in the arrow direction. at the same time, pull the cylinder and handle apart. the cylinder can be separated.
-check whether the voltage is consistent, too high or too low for use
-tighten the suction nozzle and cylinder parts before use to prevent leakage of gas or to affect the tin absorption effect
-regularly remove solder impurities into suction nozzles and cylinders and add a little oil to pistons
Four. after each use, push the piston 3-4 times to remove residual solder from the straw to keep the suction nozzle and straw open for next use
V. after the tin suction device is connected to electricity, it is strictly forbidden to installl and dismantle parts of its electric heating.
Vi. it is normal for a new tin inhaler to be used for the first time because of the heat of an electric heater and may cause a slight smoke, which will naturally disappear in ten minutes
Vii. in the course of use, a soldering iron holder with a natural heat dissipation structure shall be used and shall be placed in the soldering iron holder
Viii. if the power supply is damaged, it must be replaced by the manufacturer or its maintenance department or a similar professional to avoid danger
Ix. this product has all ground line, should be equipped with socket with contact point, please user attention to use, so as to ensure sa