Rơ Le Hẹn Giờ Dc 5v-36v Có Màn Hình Led Hiển Thị

❤ * ❤ * ❤ * Welcome to #RRIANFO *❤ * ❤ * ❤

★★★★Surprises for you★★★★
☛Follow Shop；Free gift for you！
☛High comment: Priority Shipping + 5% discount for next order！
☛Shipping within 1-24 hours!
☛Ready stock and fast shipping!
☛wish you a happy shopping!
❤ * ❤ * ❤ * information *❤ * ❤ * ❤

Features:
To achieve fast high frequency turn-on and
off circuit, an unlimited number of switching times.
No noise was made during turning on/off, no
spark, and no electromagnetic interference.
Compared to normal electromagnetic relay
modules, it has a longer service life.
Dual-MOS in parallel active output, lower inner
resistance, larger current, strong power; at room temperature, operating
current is up to 15A, power up to 400W, that can be used for most equipment.
Wide voltage input from 5V to 36V, normally
used for controlling DC motors, lights, LED strips, micro-pumps, solenoid
valves, etc., very convenient.
It has an emergency stop function ("STOP" button)
and reverse input protection.
Automatically enter sleep mode and shut off
display if no operation in 5 minutes, and will be wake up by pressing any
button.
You can set different OP, CL, LOP
parameters, which are independent of each other, and are saved separately;
All parameter settings will be saved
automatically if there is a power failure.
 

Specifications:
Voltage: DC 5V~36V.
Trigger Signal Source: High voltage level
trigger (3.0V~24V), signal ground and system ground are not on common ground to
improve the system's anti-jamming capability (you can also connect them on
common ground).
Output Capacity: DC 5V~36V, at room
temperature, continuous current is 15A, power 400W. With enhanced heat
dissipation, the current can be up to 30A.
Quiescent Current: 20mA
Operating Current:
50mA
Working Temperature: -40℃~85℃
Clocking (Time Delay) Range: 0.1seconds to
999minutes
Size: 60*34*12mm / 2.36*1.33*0.47"
 
Instruction: 
Operating Mode:
P1: trigger signal, the relay is on
"OP" time, and then disconnect; in the "OP" time, as
follows:
P1.1: signal is triggered again, invalid
P1.2: signal is triggered again, the clocking
is reset
P1.3: Signal is trigger again reset, relay
off, and stop the clocking;
P-2: trigger signal, the relay off
"CL" of time, the relay on "OP" time, and then disconnect
relay after clocking;
P3.1: trigger signal, the relay is turned
on after the "OP" time, the relay off "CL" time, then the
operation cycles; if trigger signal again during the cycle, the relay off, stop
clocking; the number of cycles times ( "LOP ") can be set.
P3.2: without triggering signal after power
on, the relay is on "OP" time, the relay off "CL" time, then
the operation cycles; the number of cycles times ( "LOP ") can be
set.
P-4: signal holding function. If there is trigger
signal, clocking is reset, the relay remains on; when the signal disappears,
after clocking "OP" time, the relay is off; if another signal is
triggered during c