Rơ Le Điều Khiển Nhiệt Độ Kỹ Thuật Số 10a Stc-1000 Stc 1000 12v

Features:
Switch the mode between hot and cold;

Control the temperature by adjusting the temperature adjustment value and the difference;

Temperature calibration

Refrigeration control output delay protection;

An alarm is issued when the temperature exceeds the temperature limit or a sensor error occurs.

All configuration parameters can be saved when closed.

It can be used in household freezers, water tanks, refrigerators, industrial refrigerators, ships, industrial equipment and other temperature control applications.

technical parameter:

-Temperature measurement range: -50°C 99 99°C

-Resolution: 0.1°C;

-Accuracy: + -1°c (-50°c 70 70°c);

-Sensor error delay: 1 minute

-Power supply: ac 110-220 v 50/60 hz, dc 12 v, dc 24 v (choose power when ordering);

-Power consumption: <3w;

-Sensor: ntc sensor (1);

-Relay contact capacity: two relays 10a/220vac; heating 10a/220vac;

-Room temperature: 0°C 60 60°C;

-Storage temperature: -30°C 75°C 75°C;

-Relative humidity: 20% 85% (no condensation water)

Key operation instructions:
-Check the parameters:

Under normal working conditions, press the "up" key to display the temperature setting value; press the "down" key to display the difference.



-How to set parameters:

In the normal working state of the controller, press the "s" key for more than 3 seconds to enter the parameter modification mode, the "setting" indicator light is on, and the screen displays the first menu code "f1".

Press the "up" key or "down" key to adjust up and down and display the menu items and menu item codes. Press the "s" key to display the current menu parameter value. Press the "s" key and "up" key or "down" key at the same time to quickly select and adjust the parameter value of the current menu value. After completing the configuration, immediately press and release the "(i)" key to save the modified parameter value and return to display the normal temperature value. If there is no key operation within 10 seconds, the system will not save the modified parameters and the display will return to normal temperature.



-Restore system data:

After power on, the system will check by itself. If there is an error output, the screen will display "er". Press any key at this time to restore the default value and enter the normal working mode. It is recommended to reset the parameter value in this