POWER Bảng Mạch Tăng Áp Dc-Dc 600w 10a Cho Arduino

"Description:
100% brand new and high quality
Feature:
VIN + is the positive input power, VIN- is the negative input power.
OUT + is the positive side of the output power, OUT- is the negative side of the output power.
Adjustable range of constant voltage: DC12-60V (turn down clockwise, turn up counterclockwise).
Constant current adjustable range: 0.2A-10A (turn down clockwise, turn up counterclockwise).
When the input current exceeds 6A, the heat dissipation needs to be strengthened (the aluminum substrate is attached to the flat metal part).
The input voltage cannot be less than 10V or more than 60V.
The maximum input current cannot exceed 10A, and the power cannot exceed 600W.
When using, you must ensure that the input voltage is lower than the output voltage by 2V or more.
Before switching on the load, please adjust the required voltage and current at no-load (the no-load voltage should be increased by 3-5V at constant current).
When using a switching power supply or other secondary power supply, please ensure that the power of the power supply is greater than double the power of the module.

Application:
1.DIY a regulated power supply, you can input 12V, the output can be 12-50V adjustable.
2.Supply power to your electronic equipment, you can set the output value according to your system voltage.
3.As a car power supply, power your laptop, PDA or various digital products.
4.DIY a high-power notebook mobile power supply: with a large capacity 12V lithium battery pack, so that your books can go wherever you go.
5.Solar panel voltage stabilization.
6.Charge the storage battery and lithium battery.
7.Drive high power LED lights.

Specifications:
Item Type: Power Supply Module
Input voltage: DC10V-60V
Input current: 10 (MAX)
Static working current: 10mA
Output voltage: 12-60V continuously adjustable (default output 19V)
Output current: 10A MAX
Constant current range: 0.2-10A
Output power: input voltagex10A
Working temperature: -40-85 degrees
Working frequency: 150KHz
Conversion efficiency: 92%-96%
Input reverse connection protection: No
Installation method: 4x3mm screw holes
Wiring mode: wiring output
Material: PCB Board
Size: 85x52x21mm/3.3x2.04x0.8in
Color: As shown
Quantity: 1 Pc

Output voltage regulation:
Adjust the CV-ADJ potentiometer and set the output voltage according to you need based on your battery or LED. Turn down the clockwise voltage and increase it counterclockwise.
Output current regulation:
Adjust the CC-ADJ potentiometer clockwise about 20 turns, set the output current to the minimum, connect the LED, and adjust the CC-ADJ potentiometer to your desired current. (For battery charging, after discharging the battery, connect it to the output, and adjust CC-ADJ to the current you need. The more power, the smaller the charging current.)
(Please do not adjust the current by short circuit. The circuit structure of the boost module cannot be adjusted by short cir