Nắp lưng kim loại Nắp đậy pin Xiaomi Redmi Note 5 / 5 pro chính hãng

Features:

--100% Original For Features:

--100% Original For Redmi Note 5 / 5 pro Back Housing Back Cover

-- 3D Glass.

--Protect your valuable investment from scratched and damage.

--It is used to Replace your broken, cracked, marked Battery Back Door Cover.

--Make your Phone new like before.


Instructions:
Disassemble the back cover:
1. First, use a household hair dryer to the edge of the back cover for 1-2 minutes (some machines are relatively tight, can not be opened and continue to , do not worry about burning the phone)
2. Second, press the back cover with the suction cup, slowly open a slit with force, insert the disassembled piece into the gap, and then slowly open it to open it. ((The suction cup should be tight, the suction is not enough to add some water)
Install the back cover:
1. First, after disassembling the back cover, it is necessary to clean the glue around the middle frame, first buckle it clean, wipe with , if not, wipe it with a wet towel. In short, there must be no residue, otherwise there will be any foreign matter. Lead to degumming later.
2. After cleaning, tear off all the green adhesive protective film on the back of the new back cover, and align it to ensure that it is stuck in one place. It can not be disassembled and reassembled twice, which will affect the viscosity of the glue. Once installed, the back cover will be pressed around for a while. Back Housing Back Cover

-- 3D Glass.

--Protect your valuable investment from scratched and damage.

--It is used to Replace your broken, cracked, marked Battery Back Door Cover.

--Make your Phone new like before.


Instructions:
Disassemble the back cover:
1. First, use a household hair dryer to the edge of the back cover for 1-2 minutes (some machines are relatively tight, can not be opened and continue to , do not worry about burning the phone)
2. Second, press the back cover with the suction cup, slowly open a slit with force, insert the disassembled piece into the gap, and then slowly open it to open it. ((The suction cup should be tight, the suction is not enough to add some water)
Install the back cover:
1. First, after disassembling the back cover, it is necessary to clean the glue around the middle frame, first buckle it clean, wipe with , if not, wipe it with a wet towel. In short, there must be no residue, otherwise there will be any foreign matter. Lead to degumming later.
2. After cleaning, tear off all the green adhesive protective film on the back of the new back cover, and align it to ensure that it is stuck in one place. It can not be disassembled and reassembled twice, which will affect the viscosity of the glue. Once installed, the back cover will be pressed around for a w