Module rơ lay cầu chì MOS công tắc hẹn giờ chất lượng cao

0.1Second (minimum)~999Minute (maximum) continuously adjustable

Description:
100% brand new,high quality
This product is simple and easy to use, powerful, but please buyers to see the operating instructions of this product in detail, very practical products.
Features:
1.Realize high frequency, fast and frequent switching of circuits, the number of infinite switches;
2.No interruption in the on-off process, no electric spark, no electromagnetic interference;
3.Longer service life than conventional electromagnetic relays;
4.Adopt doubleMOSParallel active output, lower internal resistance, higher current, and powerful power,Room temperature15A,400W,Meet the use of most equipment;
5.Often used for controlMotor, bulb,ledLight strip, DC motor, micro water pump, solenoid valve, etc.,This module makes it easy to control these devices.
6.Pulse Generator only, other accessories demo in the picture is not included.

Specifications:
1:Operating Voltage: DC 5V--36V;
2:trigger signal source: high level trigger (DC 3.0V-24VThe signal ground and the system ground do not jointly improve the anti-interference ability of the system (also can be short-circuited by itself)
3:Output capacity: DCDC 5V--36V, continuous current at normal temperature15A, power400W! Maximum current is reached under auxiliary cooling conditions30A.
4:Static current: 15mA
5:Service life: unlimited switch; working temperature: -40-85 ° C; size: 6.0 * 3.4 * 1.2 cm
6:With optocoupler isolation, enhanced anti-interference ability, industrial grade circuit board, set parameters forever after power offmemory.
7:Item Type: Pulse Generator
8:Material: Fiberglass sheet + electronic components
9:Size: approx.60x32mm /2.36x1.2in
10:Quantity: 1 Pc

Operating mode:
P1mode:After the signal is triggered, the relay is turned on.OPTime, then disconnected;OPTime, as follows
P1.1:Signal trigger againinvalid
P1.2:Signal trigger againRetime
P1.3:Signal trigger againReset, the relay is disconnected, stop timing;
P-2: give the trigger signal, the relay is disconnectedCLAfter the time, the relay is turned on.OPTime, after the timing is completed, disconnect the relay;
P3.1: give the trigger signal, the relay is turned onOPAfter the time, the relay is disconnectedCLTime, then loop the above action, give the signal again in the loop, the relay is disconnected, stop timing; the number of cycles (LOP) can be set;
P3.2: No need to trigger signal after power-on, relay is turned onOPTime, relay disconnectedCLTime, loop the above actions; number of cycles (LOP) can be set;
P-4: Signal hold function If there is a trigger signal, the timing is cleared, the relay remains on; when the signal disappears, the timingOPAfter the relay is disconnected; during the timing, there is a signal and the timing is cleared;


Note:
Module isActive live output, the voltage at the output (load end) is equal to the input voltage (DC 5V--36V).
‘DC+'And load‘+'The poles themselves are internally shorted, but ‘DC-'with load‘-'The two