Máy Khắc Gỗ Mersavo Cnc Z-Axis Tự Động Mach3

Specification:
Material: wire+metal
Color: as pic shows
Size: approx. 1.38*0.79inch/3.5*2cm (D*H)
Effective surface of the knife: 25mm (0.98inch)diameter
Line length: approx. 49.21inch/125cm (Including alligator clips)
Two ways to connect this item:
if your interface board has the limit switch port or other probe port, you can connect it to that port
if your interface board does not have that port, your driver board has that port, you can connect it to the driver board's limit switch port
then in the Mach 3, you need to setup the probe(Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. in the attachment, it is the code, you can edit it as your requirements
Usage:
The wire connect on the control panel interface.
The clip and the control board GND (negative) is connected.
The tool can be clamped portion of the operation when the knife with a clip.
When the tool contacts the knife that the process is complete.
Package included:
1x CNC router engraving machine Tool
Note:
1.Due to the manual measurement and different measurement methods, please allow 2-3cm deviation.
2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the website's photo and the actual item could be slightly different.
Before any purchase pls check carefully about the detail information of the pruduct.


• If you wish to change details after you placed an order, please cancel the order within 30 minutes and place a new one. If you miss out the correct step your order will not be allowed to cancel order/change.
• When received the parcel, please check before you click button "order received".
• Please contact us if you have any concern before opening a dispute, give us an opportunity to resolve the problem.

#MACH3 #ZAxis #Engraving #Routers #Instrument #Auto-Check #cnc #Touch #Settings #