Máy In Epson L110 L120 L210 L220 L300 L310 L350 L360 Eprom 25px80

"Important"
Please list your printer series because each printer uses different software / firmware

If your printer is the epson l110 series, then the eprom ic will be adjusted using the l110 program. So you don 't have to program it first because we' re going to program it, so you just installl the eprom ic and your printer automatically reset the counter.

Example:
You order 5pcs eprom ic, then you can list:
- 2pcs epson l110
- 1pc epson l120
- 1pc epson l210
- 1pc epson l310



The ic 25px80 supports the l110 l120 l210 l220 l300 l310 l350 l360 printer but must be programd first.


Eprom epson l110 l120 l210 l220 l300 l310 l350 l360 25px80 25q16bv, eeprom reset epson l110 l120 l210 l220 l300 l310 l350 l360, epson printer resetter | Ic eprom, transistor, diode, fuse
Eprom epson ic l110 l120 l210 l220 l300 l310 l350 l360, ic counter l110 l120 l210 l220 l300 l310 l350 l360, ic eeprom reset epson l110 l120 l210 l220 l300 l310 l350 l360

In epson 's latest series of printers many cannot be reset by using the l110 l120 l210 l220 l300 l310 l350 l360 software or software adjustment. For such constraints it can be overcome by replacing the eeprom ic on the mainboard. In addition, the eeprom ic can be implemented to solve problems with the mainboard with bios error or corrupt.

Condition:

New
Ic code: 25px80 / 25q16bv
Already programd
100% tested and running normally


Printer support (please insert your printer series at order):

Epson l110.
Epson l120.
Epson l210.
Epson l220.
Epson l300.
Epson l310.
Epson l350.
Epson l360.

Eprom l110 l120 l210 l220 l300 l310 l350 l360:

- lce feet with flux
- soldering ic feet with a little tin, make sure tin fuses with the ic legs, this is done because the ic legs have never been hit by tin.
- put ic on board according to position, don 't flip.
- imperfect installlation (tin is not fused on the ic feet). Resulting in error or blink 9x
- the hot ic can break and blink 9x too.


Please be careful when removing the ic, because if too hot the blower is used then the other components are damaged which causes the mainboard to fail or the pcb path to b