Dụng cụ hàn điện đa năng

Product characteristics:
842a、 new structure、 features of easy to use tin absorption cleanness and so on, using it, it is easy to remove the replacement components from the circuit board, without damage to components and circuit boards. For replacement of integrated circuits、 the advantages of multifoot switches are more prominent. This tin absorber can be used for general electric iron, it is defense、 scientific research、 communications、 airways、 computers、 broadcasting、 television、 electronics professional maintenance staff and radio enthusiasts must be tools.


Methods of use:

I、 220v-50hz, power 30w
Ii.、 access to power supply, preheating 3-5 minutes
Iii.、 push the piston handle down, the front end of the tin-hot iron suction is directed at the solder point to remove the element, after melting of solder, press the control button, solder is inhaled into the cylinder
Iv.、 the tin absorber is equipped with two different diameter suctions, can be selected according to the coarse selection of components lead
V、 welding, operations like the use of iron
Vi、 when removing the cylinder, press the upper end of the cylinder and press the arrow., pull the cylinder away from the handle simultaneously, the cylinder can be separated, disassembly of the inhalation tsui, rotate the suction in counterclockwise direction, remove tips from the suction
- checking whether the voltage is consistent with the use of the voltage, too high or too low voltage is not good for use
- tighten the suction and cylinder parts before use, to prevent leakage, otherwise, the effect of tin absorption
- regular removal of solder impurities into the suction and cylinders, and add a little oil to the piston
Iv.、 after each use, push piston 3-4 times, to remove solder residues in the tube, open the suction and suction tubes, for next use
V、 after tin suction, it is strictly forbidden to install and dismantle parts of their electrical heat.
Vi、 new tin absorbers may smoke slightly when they are first used because of heating electrical components, this is normal, it will disappear naturally in ten minutes
Vii.、 in use, the iron seat with natural heat dissipation must be used and placed in a hot iron seat
Viii、 if power supply soft wire is damaged, to avoid danger, must be replaced by the manufacturer or its maintenance department or similar full-time staff
Ix、 this product has all lines, use of sockets with contact points, please note the use of, for safety.

Include:

1x


1xpcb