Máy Hàn Mini Cầm Tay 18650 Kèm 2 Dây Nguồn

Package Included:
1 controller
2 x soldering pen
2Pcs x power input line (red and blue)
1 pair x U-shaped cold-pressed terminals (used to connect to the input power supply)
1 x black plug (when you select manual mode, an external trigger switch is required to connect the black plug.)

feature:
1. Wide selection of welding power supply: lithium battery power supply or 12V car battery.
2. The controller is controlled by a single-chip microcomputer, and the output pulse is accurate to ensure the welding quality.
3. With LCD display, welding parameters can be displayed.
4. The soldering pen and the input wire are connected through U-shaped cold-pressed terminals, which is easy to disassemble and replace.
5. Use automatic butt welding mode, while retaining the manual trigger interface, you can choose according to your own use.
6. The power board uses 2 strands of bronze to increase the overcurrent capacity.
7. Use 5 * 300A MOS tube, undisassembled MOS tube.
8. MOS tube driver adopts imported special chip driver. The fastest MOS tube can reach 20nS. The switch is fast and can prevent the explosion of electronic tube and non-triode push-pull drivers.
9. The MOS driver design adds a transient diode to protect the MOS and prevent the tube from exploding.
10. Use 10AWG multifilament soft wire for soldering pen wire and input wire to increase the overcurrent capability.
11. The controller is mainly used for welding 0.1mm to 0.15mm nickel-plated steel strip.
12. A 25V10000uF high-frequency low-resistance capacitor is added to the power input terminal to compensate for energy, thereby improving the welding stability.

specification:
material: metal
Input line length: about 20 cm/7.87 inches
Soldering pen length: about 30cm / 11.81in
Color: red + blue + black
Battery: 18650 lithium battery (not included)
Quantity: 1 set

note:
The controller comes with a 20cm long 10AWG input cable. One end has been crimped with a U-shaped terminal, and the other end has not been processed. Connect the crimped U-shaped terminal to the control power input terminal, and the other end will be processed according to its own power supply.
There is an ignition switch under the control panel. After pressing, wait 3 seconds. After the bell rings, the LCD screen lights up, and the startup is complete. Press the power switch again to turn it off.
Due to manual measurement, please allow 1-2 cm size error.
The color of the items shown in the photo may be slightly different on the computer monitor because the monitor is not calibrated the same.

[Come and see my shop:]
Shipped on the day of purchase, all products are available in stock
You will get the biggest discounts and the most satisfactory products,
If you are satisfied with our products, please rate us ⭐️⭐️⭐️⭐️⭐️
If you are not satisfied, please contact us before scoring! !
100% ready-made inventory; guaranteed to be shipped as soon as possible after the order is successful; the average arrival time is 5-7 days after shipme