Kit phát triển C2000 Piccolo MCU F280049C LaunchPad, chính hãng TI

Kit phát triển C2000 Piccolo MCU F280049C LaunchPad
Bao gồm:
- 01 Kit Piccolo F280049C Launchpad
- 01 Micro USB cable
- 01 Quick Start Guide

Features
Hardware Features
TMS320F280049C: 100 MHz C28x CPU with FPU and TMU, 256 KB Flash, InstaSPIN-FOC enabled, 3x 12-bit ADC, CAN, encoder, FSI, UART, and more
On-board XDS110 debug probe for real-time debug and flash programming
80 pin LaunchPad leveraging the BoosterPack ecosystem
Power domain isolation for real-time debug and flash programming
Isolated CAN transceiver
Two encoder interface connectors
FSI interface connector
Hardware Files are in C2000Ware at boards\LaunchPads\LAUNCHXL_F280049C
Software Features
Free download of Code Composer Studio IDE
Free download of C2000Ware for device drivers and example projects
Free download of MotorControl SDK
MathWorks Embedded Target Support
solidThinking Embed Support
Training Video: PMSM control series, including InstaSPIN-FOC
Powersim PSIM Support
InstaSPIN Processor-in-the-Loop (PIL) and code generation feature

Recommended BoosterPacks
BOOSTXL-DRV8320RS
TI BoosterPack Checker for an interactive list of compatible BoosterPacks

Get Started
For InstaSPIN-FOC
Download MotorControl SDK and follow User’s Guides

For non-InstaSPIN
Install Code Composer Studio IDE and C2000Ware.
Connect the LaunchPad using the included Micro USB cable to a computer
Open a serial terminal program of your choice (Putty, HyperTerm, etc.) and configure it to access the LaunchPad virtual COM port with 115200 Baud, 8-bit data, No parity, and single stop Bit. The COM port number can be found by opening your computer’s Device Manager
Ensure that the XDS110's second port is a serial port. Refer to the XDS110 Wiki for the configuration details
When connected to your computer, the LaunchPad will power up and flash the red and blue LEDs for approximately 3 seconds. After the LEDs complete flashing, the LaunchPad will enter an ADC sample mode
The terminal will display the latest ADC sample reading based on ADCINA5 (Pin 23 of the BoosterPack header) at a one second interval
If the sample is below mid-scale (1.5V/2048) the green LED (LED5) will light
If the sample is above mid-scale the red LED (LED4) will light
Build and load other examples in C2000Ware
Ask questions on the TI C2000 e2e forum
#proe #C2000 #MCUF280049C
www.pr