Kekeshop TB6600 4A Stepper Motor Driver 9~40V Micro-Step for 42/57/86 Steppers

Feature:
1. Stepper motor driver's quiescent current will be automatically halved and it is with 8 available output currents, which can be up to 4.0A.
2. With built-in temperature protection and overcurrent protection, motor driver supports H-bridge bipolar constant-phase flow drive.
3. As the upgraded version of TB6600, the subdivision is increased to 32 subdivisions, suitable for high subdivision purposes.
4. Keeps input signal high-speed photoelectric isolation, driver board provide energy-saving semi-automatic current lock function.
5. The semi-closed casing can adapt to more severe environment. And this driver board keeps simple installation.

Specification:
Item Type: Stepper motor driver
Model: TB6600 upgraded version
DC Power Supply: 9V-40V DC power supply
Eight Kinds of Output Current Available: Maximum 4.0A
6 Subdivision Modes Available: 32 subdivisions
Standard Common Positive Single Pulse Interface: Yes
Offline Hold Function: Support
Protection: Built-in temperature protection and overcurrent protection
Weight: Approx. 201 g / 7.1 oz
Applicable Stepper Motors: 42, 57 and 86 type 2 phase 4 phase (4-wire 6-wire 8-wire)
Definition of Terminal:
Signal Input:
⑴CP+: Pulse signal input positive terminal.
⑵CP-: Pulse signal input negative terminal.
⑶DIR+: Positive end of motor forward and reverse control.
⑷DIR-: The negative end of the motor's positive and negative control.
⑸Enable+: Positive end of motor offline control.
⑹Enable-: Motor off-line control negative terminal.
Motor Winding Connection:
⑴A+: Connect the A+ phase of the motor winding.
⑵A-: Connect the A-phase of the motor winding.
⑶B+: Connect B+ phase of motor winding.
⑷B-: Connect B-phase of motor winding.
Working voltage connection:
⑴Volt Current Condenser: DC power supply is positive (
Note: 10V ＜VCC ＜42V).
⑵Ground: Negative DC power supply
Signal Input: Optocoupler isolation connection
Two Connection Methods for Input Signal Interface: The user can adopt the common anode connection method or the common cathode connection method as needed.
1. Common Anode Connection Method: Connect CP+, DIR+ and EN+ to the power supply of the control system respectively. If the power supply is +5V, it can be directly connected. If the power supply is higher than +5V, an external current limiting resistor R must be added. To keep that the drive current of 8-15mA is provided to the internal optical coupling of the driver. The pulse input signal is accessed through CP-; at this time, DIR- and Enable- are active at low level.
2. Common Cathode Connection: Connect CP-, DIR-, Enable- to the ground terminal of the control system (SGND, isolated from the power ground); the +5V pulse input signal is added through CP+; at this time, DIR+, Enable+ are in Active high. The connection value of the current limiting resistor R is the same as the common anode connection method.

Package List:
1 x Stepper Motor Driver

Note:
The Enable terminal can not be connected. When Enable