[Iuxishop] LED Display Delay On/Off Relay Module Trigger Cycle Timer Switch DC 5-30V

_______♤Welcome Iuxishop Store♤___________

✔Ready Stock
✔COD
✔Quality Checked
✔Whole Items: Good Quality/Ready Stock/Original/Wholesale Price
✔Shipping Time: 5-14 usually 8 days from China

★Surprises for you★
☛Free Gifts:Follow Shop
❤“Like” 5 Items: Priority Shipping
⚠️( Sent us follow shop screenshot and remark on your order "Free Gift", if not will miss)

✌(Tip:We will be based on your guests in your country to send the corresponding adapter plug)

【After-sale】: If there are any problem, please contact us firstly, we will try our best to solve it.

__________________❀Product Information❀__________________

Features:
0.1 seconds to 999 minutes continuously adjustable. 
Wide power supply voltage (6~30V), supports micro USB 5.0V power supply.
One-key emergency stop function, with reverse polarity protection to prevent burn-out.
Add sleeping mode, no operation for 5 minutes, automatically turn off the display, and press any button to wake it up.
Different OP, CL and LOP parameters can be set, which are independent and saved separately.
All setting parameters are automatically saved after power-off.

Specification:
Supply voltage: DC 6-30V, supports micro USB 5.0v power supply
Trigger signal: High level (3.0V-24V) (The signal and system don't use the same GND port)
Output capacity: DC 30V/5A, AC 220V/5A
Static current: 20mA
Working current: 50mA
Life: >100,000 times
Working temperature: -40~85℃
Size: 6.2*3.8*1.7cm / 2.44*1.5*0.67om
Weight: Approx. 27g
 
Instruction: 
1. Working Mode:
P1: After signal triggers, the relay opens for "OP" time, and then disconnect; in the "OP" time, as follows:
P1.1: signal is triggered again, invalid
P1.2: signal is triggered again, restart the timing
P1.3: Give trigger signal, the relay closes for "CL" time, then opens for  OP" time; After finishing the timing, disconnect the relay;
P3.1: Give trigger signal, the relay opens for "OP" time, then closes for  CL" time, then the operation cycles; if give trigger signal again during the cycle, the relay opens, stop timing; the cycles times ( "LOP ") can be set.
P3.2: No triggering signal required after power on, the relay opens for "OP" time, then closes for "CL" time, then the operation cycles; the cycles times ( "LOP ") can be set.
P-4: Signal holding function: If there is trigger signal, timing is cleared, the relay remains on; when the signal disappears, after "OP" time, the relay is off; if another signal is triggered during timing, timing will be cleared.
 
2. How to Set Timing Range:
After setting the parameter value at mode selection interface, short press "STOP" button to set the timing range;
XXX. - timing range: 1 second to 999 seconds.
XX.X - timing range: 0.1 seconds to 99.9 seconds
X. X. X. - timing range: 1 minute to 999 min