( HÀNG có sẵn ) Chân vịt xếp li cho máy may ( không kèm túi đựng )

1. Function: The pleating device makes pleating easier. Use them to make pants, stylish highlights on the skirt, hem of the curtains, or the ruffles of the bed cover and the sofa cover. You can make pleats or pleats, even if you can sag and pleat at the same time. 2, operation: machine stitch straight stitch
Raise the lift bar to the highest position
Install the pleating device and place the fork on the needle clamp to ensure that the presser foot and needle clamp screw can operate normally.
Check if the needle is in the needle holder of the pleating device
After slowly lowering the needle, thread the needle thread into the pinhole and tilt the needle box bobbin thread through the teeth.
 Pleated correctly placed fabric pleating
 Lift the adjustment lever to move it to the adjustment inlet slot 1
Put the fabric between the blue knife and the separator knife and dial the first separator rod
Lightly pull the fabric behind the needle
Place the needle, lower the presser foot, and start sewing
Adjust the adjustment indicator to a larger number, the pleats are denser; the smaller numbers, the pleats are more sparse.
 Even if the same number of pleats are placed per needle, the length of the needle still affects the density of the pleats. Shorten the needle, it will make a tighter pleat, and the longer needle will make less pleats
 (ordinary) pleat
 1. Move the adjustment lever to 6 or 12 slots
 2. Adjust the length of the needle, the needle is shorter, and the pleats can be dense
 3. To make deep pleats, adjust the indicator to 8
 4. Put the fabric between the blue knife and the separator knife and dial the first separator rod
 5. Lower the presser foot and needle
 One step pleating
 Place the pleat between the blue knife and the separation knife and lower the first separation guide.
Dispense the fabric under the blue knife (between the separator knife and the teeth) while sowing the first separator rod
Start to make the pleats of the pleats. When the sutures are sewn into the inside, the right side of the material will gather together. 3. Note; the pleating device should always be oiled to prevent sticking during operation. A drop of sewing machine oil is sufficient at the mark below. After the oil is finished, use the pleated pieces to wipe off the excess