Giá Đỡ Bằng Hợp Kim Thép Cứng Cho Máy Nén Khí Msqb10A 10mm

Welcome to rriioo
We offer the highest discount
Follow us and get coupons
Our shop has a rich variety of products, affordable prices and good quality
Don't miss us, come and buy! ! !
If you have any questions, please contact us

Feature:
1. This pneumatic air cylinder is rotating table type, easy to work and install, improve work efficiency
2. Adopt roller bearing design, load is 3 to 4 times larger than for CRQ series, very practical
3. Smooth and accurate swing, built-in magnetic ring, so that magnetic switch can be installed
4. Alloy steel material, posse high strength, high toughness, wear resistance, corrosion resistance
5. Action type is double action, the angle adjustment range is 0-190℃, which is very flexible, and the bore is 10mm

Specification:
Item Type: Pneumatic Air Cylinder
Model: MSQB10A
Bore Diameter: Approx. 10mm / 0.4in
Medium: Air
Action Type: Double action
Angle Adjustment Range: 0-190℃
Connection Pipe Diameter: M5x0.8
1. Type Selection:
According to the working requirements and conditions, the correct type of cylinder is selected. Requires that the cylinder reaches the end of the stroke without impact and impact noise. Buffer cylinders should be selected; for light weight, light cylinders should be selected; for narrow installation space and short strokes, thin cylinders are optional; for lateral loads, cylinders with guide rods are optional; requirements For high braking accuracy, lock cylinders should be selected; piston rods are not allowed to rotate, and cylinders with non-rotating rod function can be selected; heat-resistant cylinders should be used in high temperature environments; corrosion-resistant cylinders should be used in corrosive environments. In harsh environments such as dust, it is necessary to install a dust cover on the extension end of the piston rod. When no pollution is required, oil-free or oil-free lubrication cylinders should be selected.
2. Installation Form:
Determined according to factors such as installation location and purpose of use. In general, a fixed cylinder is used. When it is necessary to continuously rotate with the working mechanism (such as lathes, grinders, etc.), rotary cylinders should be used. When the piston rod is required to move in an arc in addition to linear motion, shaft pin cylinders are used. When there are special requirements, the corresponding special cylinder should be selected.
3. The Size of the Force:
That is, the choice of bore. Determine the thrust and pulling force output by the cylinder according to the size of the load force. Generally, the force of the cylinder is required to balance the conditions of the external load theory, and different load rates are selected according to different speeds, so that the output force of the cylinder has a little margin. If the cylinder diameter is too small, the output power is not enough, but the cylinder diameter is too large, making the equipment bulky, increasing the cost, increasing the gas consumption,