Đồng Hồ Đo Tốc Độ Xe Đạp Có Đèn Led Chống Nước

Features:
1. Integrated with 2 T6 LED, Designed for brightness of 800 lumens, up to 350m illuminating distances, 95° light angle.
2. Made of high quality ABS material, IPX65 waterproof rated.
3. Wirelss connection ,precise measurement for viewing total distance, maximum speed, average speed etc..
4. Built-in 4000mAh battery, usb rechargeable, no more costs on batteries.
5. Five sound modes, 4 lighting modes, easy to switch.
6. Increased the safety of riding With Warning tail light , see and been seen at night.

Specifications:
Name：NEWBOLER 3 IN 1 Bike Computer Horn Headlight Sets
Headlight brightness: 800 lumens
Lighting mode: High/Low/Flash
Effective range: 200m
Electronic horn: About 120 dB
Sound: 5 Sounds can be switched
Light working time: 5~10hrs
Computer working time: 3000hrs
Rechargeable Battery: 4000mAh
Tail Light Battery: CR2032 ( tail light is optional , battery last for 5-6 months)
Headlight Charging: USB charging
Headlight Recharge time: 4hrs
Sensor battery: CR2032
Sensor working time: 12months, 1hr/day
Waterproof: IP65
Weight: about 145g
Size: about 110*40* 35mm
Color: Red / Blue / Green / Black

How to set speedometer;
Keep Press MODE key and SET key for 5 seconds at the same time, the host enters the setting state, when setting, away from the display and other electronic products, it may be interfered, do not turn the wheel when setting, when the motion signal is received, the setting will automatically exit. Press the power key to exit the setting when the setting is complete.

How to install;
1. Loosen the magnetic head by hand and install it on the spokes.
2. Affix the rubber sticker to the receiver.
3. Install the inductor on the front fork opposite the brake.
4. The alignment of the head between the two sensors must not exceed 3mm.

List of Package
1 * Bike front light
1 * Mounting Bracket
1 * USB Charging Cable
1 * Wireless Data Receiver
1 * Data Sensor
1 * Rubber foot for sensor
4 * Fixing Strap
1 * Speaker controller
1 * User manual


Details Setting for Odometer
[1]Enter the tire perimeter setting, press the MODE key to set the value from left to right, and press the SET key to change the value. A total of four values need to be set in millimeters.
[2]Enter the metric/imperial setting, press SET to switch between metric/imperial units, and press MODE to confirm.
[3]Weight setting, press the SET key to set the value from left to right, the unit is KG, press the MODE key to confirm.
[4]Clock setting: press the set key to set the value, press the MODE key to switch the next bit,
[5]Reserve the location of the setting, please ignore this setting
[6]When the settings are complete, press the power key to exit the settings

Important Tips
For possible reading inaccuracies, customers should know the following information
1. the distance between monitor and sensor should below 70 cm
2. the distance between sensor and magnetic should below