[COD]USB GPS Receiver For Car Laptop PC Navigation GPS Antenna Receive And Transmit


₫ 286.000

Sản phẩm [COD]USB GPS Receiver For Car Laptop PC Navigation GPS Antenna Receive And Transmit đang được mở bán với mức giá siêu tốt khi mua online, giao hàng online trên toàn quốc với chi phí tiết kiệm nhất,0 đã được bán ra kể từ lúc chào bán lần cuối cùng.Trên đây là số liệu về sản phẩm chúng tôi thống kê và gửi đến bạn, hi vọng với những gợi ý ở trên giúp bạn mua sắm tốt hơn tại Pricespy Việt Nam

GPS-Antenna-Navigator-Amplifier-5M-16FT- Car-Signal-Repeater-Amplifier-GPS-Receive-And-Transmit-for-Phone

Specification:

Center Frequency(MHz): 1575.42

Bandwidth(MHz): 6

Input Impendence: 50

V.S.W.R: <1.5

Consumption Electric: <15mA

Polarization Intensity: R.H.C.P

Supply Voltage: USB 5V

The Sound Coefficient: <1.5dB

Axial Ratio: 30Db

Gain(dBi): 29dB±3dB(LNA)

Operating Current: < 20mA

Cable Length approxi. 5M/15FT(receiver part) 2M/6FT(transmitter part)

-Inductive antenna installation:

The receiver in the car by the adsorption position of the trunk; Cable into the car from the rear door or the back seat of the car door , and then go to the next floor mats beneath the center console , connect the transmitter, the transmitter is placed above the center console storage box , or , finally received through the power to work.

-Power plug: USB plug interface provide voltage antenna, supporting Mini car cigarette lighter to USB power plug

-Receiver: Mounted on the vehicle , the vehicle receives a strong GPS signal , and amplified for transmission to the vehicle .

-Transmitter: Mounted in the vehicle , after the receiver amplifies the signal transmitted again transmitted to the car, so the car navigator receives the equivalent of three or four times external signal strength .

Installation Guide:

1. The receiving end of the upper magnets mounted outside the vehicle trunk , facing the reception .

2. The transmitter installed in the center console under the windshield or front passenger storage compartment , pay attention to the emitting surface ( black shell surface ) for GPS Location of the device ( navigator ) is located, and to ensure that the transmitter from GPS Less than one meter from the device , the transmitter and GPS No metal block between devices in order to achieve the best results.

3. After he receiver and the transmitter is installed, connect USB power partwith the cigarette lighter ( input voltage DC16V Or less ), power side indicator light , which means that work properly, then start GPS Equipment.

Package Included:

1 x Antenna transmitter

1 x Receiver

1 x

Sản Phẩm Liên Quan

HOT

Bikini hàng Âu

₫ 400.000
HOT
HOT

Bikini Thái

₫ 300.000
HOT

Bikini OKISS- QCXK

₫ 400.000
HOT

Bikini xuất Âu

₫ 300.000