Chip Atmega8-16Pu Chính Hãng + Bốtloader Optiboot Arduino

🌁 Original ic atmega8-16pu chip + optiboot bootloader arduino compatible





💥💥💥
Ic atmega8a + optiboot bootloader for programmable using arduino ide

High-performance, low-power avr.® 8-bit microcontroller
Advanced risc architecture
130 powerful instructions.
Most single-clock cycle execution
32x8 general purpose working registers
Fully static operation.
On-chip 2-cycle multiplier
High endurance non-volatile memory segments
? 8k? Bytes of in-system self-programmable flash memory program
? 512? Bytes eeprom 1k byte internal sram
Write / erase cycles: Flash / eeprom
Retention data: 20 years at 85°C / 100 years at 25°C (1)
Optional boot code section with independent lock bits
In-system programming by on-chip boot program
- true read-white operation
Two 8-bit timer counter with separate prescaler one compare mode
One 16-bit timer counter with separate prescaler compare mode and capture mode
Real time counter with separate oscillator three pwm channels
8-channel adc in tqfp and qfn / mlf packageeight channels 10-bit accuracy
6-channel adc in pdip packagesix channels 10-bit accuracy
Byte-oriented two-wire series interface
Usart series programmable
Master / slave spi serial interface
On-chip analog comparator
Special microcontroller features
Power-on reset and programmable brown-out detection
Internal calibrated rc oscillator
External and internal interrupt sources
Five sleep modes: Idle, adc noise reduction, power-save, power-down, and standby
I / o and packages
23 programmable i / o lines
28-lead pdip, 32-lead tqfp, and 32-pad qfn / mlf
Operating volts
2.7-5.5v (atmega8l)
4.5-5.5v (atmega8)
Speed grades
0-8 mhz (atmega8l)
0-16 mhz (atmega8)

💥💥💥





👱‍♀️📍 Read compulsory notes before transactions
👱‍♀️📍 Check stock before order
👱‍♀️📍 The products that have been purchased cannot be returned
👱‍♀️📍 Do not accept any return & complaint in any form
👱‍♀️📍 Original ic atmega8-16pu chip + optiboot bootloader arduino compa