Bảng Mạch Điều Khiển Bay F4 Pdb Osd Stm32 Cho Máy Bay Điều Khiển Từ Xa

Description:

English name: F4 flight control Betaflight F4 PDB STM32 integrated OSD flight controller DSHOT

Product description: This is a flight controller for mainstream FPV small racks using STM32F405 and mpu6000. 

Input voltage is 2S-6S

BEC:5V
Output 3A current.
Applicable: It supports the mainstream PPM, SBUS, IBUS, DSM2/DSMX and other receptions on the market. machine.
There are LED_STRIP interface, active buzzer interface. Integrated OSD function, support OSD parameter adjustment, support the latest DSHOT ESC.

Hardware Configuration:

Main control: STM32F405RGT6

Sensor: mpu6000

Receiver: Support PPM, SBUS, IBUS, DSM2/DSMX, etc.

LED_STRIP interface

Active buzzer interface

No black box

Built-in ammeter, current detection

OSD interface

Comes with BEC 5V 3A

Dimensions 42*36MM (including the pad length of the bonding wire)

Screw hole spacing 30.5*30.5MM

Diameter 4.1MM

Weight 9.4g

 The new F4 flight control:

1. Use OMNIBUSF4 firmware

2. The main control is STM32F405 GRT6, the refresh rate is up to 8K.

3.PCB 3OZ copper thickness to enhance current stability and fast heat dissipation

4. BEC is 5V3A output

5

ESC M1-M4: Connect the power cord of the ESC

V+-V-: Corresponding to the positive and negative poles of the power cord of the ESC, with a ‘-’ sign as the ground wire.

B+--B-: lithium battery input

BOOT: BOOT button (used to flash firmware)

+5V: With 3A output, it can be connected to the image transmission, receiver, and camera at the same time.

GND: Ground wire

Vout: Video output, connected to video transmission image signal line

Vin: Video input, connected to the camera signal line

LED: Programmable LED_Strip signal line output port

RX6(S): Connect SBUS receiver here

RX1(D): Connect DSM2/DSMX/IBUS receiver here

PPM: Connect the PPM receiver here

VBAT: The positive pole of the wide voltage graph transmission power supply (synchronized with the battery voltage), where the voltage is the power voltage

BUZ+, BUZ-: BB ring connection (only supports active buzzer, distinguish between positive and negative)

 RX3, TX3: serial port URAT3

Packing list: 

F4 flight control*1 pc

shock-absorbing ball*4pcs

Note：

1.Please allow 0-1cm error due to manual measurement. Please make sure you do not mind before you bid.

2.Due to the difference between different monitors, the picture may not reflect the actual color of the