27MM Guitar Pickup Piezo Transducer Amplifier With 6.35MM Jack

2 Set pickup: 1 Set with gasket & 1 Set with glue block
Pre-wired piezo mic save time for you, easy to install, convenient to use. You can attach the piezo in or on your build, drill a hole and mount the jack
Drill a hole from inside the body, loosen the end-pin jack nut,insert it to the hole and tighten the nut
Very easy to install and sounded good through several different amps, No Soldering Required, No Battery Required.With the advantage of being able to eliminate interfering external sounds and not be influenced by sound reflections from nearby objects

Material: Plastic+ Metal
Color: Black
Installation instruction:
1 Take the plastic film down from the back of transducer to expose the adhesive
2 Place the transducer through the sound hole to the lower part of the front body where the guitar produces the best tonal response
3 Drill a hole from inside the body, loosen the end-pin jack nut, insert it to the hole and tighten the nut
The above procedures depend on different instruments.
Very easy to install and sounded good through several different amps.
Plug Dia. : 6.35mm/0.25 inch; Cable Length(Approx.) : 35cm/ 13.78 inch.
Suitable for Guitar Violin Ukulele Mandolin Banjo box Guitar.
With the advantage of being able to eliminate interfering external sounds and not be influenced by sound reflections from nearby objects.
Cable long : approx 32cm
Plug Dia: approx 6.35mm/0.25 inch
Type: 1 to 2
Pickup Dia: 30mm/1.2inch
Plug Hold Dia.: 6mm/0.24inch
Plug Thread Dia.: 12mm/0.47inch
Cable Length(Approx.): 55cm
Cable Tie Size: 115x2mm/4.4inchx0.08inch(LxW)
Tie Mount Base Size: 28x28x6mm/1.1inchx1.1x0.24inch(LxWxT)

Package Contents:
2 x pickup
1 x glue block
1 x Cable tie
4 x gasket
1 x knobOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1