150W DC-DC Boost Converter Step Up Power Supply Module 10-32V To 12-35V 10A Laptop Voltage Charge Board

Description:

Module Properties: non-isolated step-up module (BOOST)
65 * 56.5 * 23 (length * width * high) (mm)
Input Voltage :10-32V (Default with low voltage operation, low voltage operation is used for automobile electric fire instantaneous power down.
This module cannot operate under low pressure for long periods of time.
Output voltage: 12-35V(adjustable)
Output Current: 10A (MAX)
Input Current: 16A (MAX) (Please enhance heat dissipation if more than 10A)
Output power:
natural cooling 100W (MAX) and Enhance heat Dissipation 150W (MAX)(When using, please decide whether to add fan with more practical conditions,
And be sure to ensure that the heat exchanger temperature does not exceed 80 ° C.)
Easy to drive 65W 90W dual-core notebook.
Use a 12V Battery Drive 19V 3.42A Notebook, The Module Temperature About 45C
Conversion efficiency: 94% (measured at Input 16V, output 19V 2.5A)
Output Ripple: 2% (MAX) 20M-bandwidth
Operating Temperature: Industrial (-40c to +85c) (ambient temperature exceeds 40c, lower power use, or to enhance heat dissipation)
Full load temperature rise: 45c
No-load current: 25mA typical
Voltage regulation: 0.5%
Dynamic response speed: 5% 200uS
Short circuit protection: None (Please Install fuses and protection circuits at Input port.)
Input Reverse Polarity Protection: None (Please Series diode at the input port.)
Wiring mode: no welding, terminal

Precautions:
1.12V conductor length less than 1 meter conductor is not less than 1.5 square, if the length is greater than 1 meter, please thick conductor.
2. When the module works in high power, high temperature and adding the shell, please install a fan. For small power, no fan is needed.
3. In use, the input cannot be connected to the reverse output and cannot be short-circuited.
4.12V battery discharge voltage shall not be less than 10.5V, lithium battery used in series (single 3.7V) discharge voltage shall not be less than 2.7V.
5. In + :input positive, IN-: input negative, OUT+ :output positive, OUT-: output negative.


Range of application

1).DIY an output adjustable car power supply, only need to access your 12V power supply in the input, the output voltage you can (14-35V) free continuous adjustment, but the output voltage can not be lower than the input voltage.

1) Power supply of vehicle-mounted notebook.

The input is connected to your 12V power supply, and the output can be adjusted to the voltage of your notebook.

2). Booster charger, you can use 12V power supply to charge higher than 12V battery, such as 24V battery.

3). Power supply for your electronic equipment can work normally as long as the voltage is adjusted to the voltage you need and the current does not exceed the rated current.

4). System level power supply before, when you are doing a project when the input is 10 to 18 v, and your system board and will need about 24 v power supply and the power is large, using ordinary DC - DC module power is too small, do you choose this module will be yo