1 Pcs Dc 5V-12V 6V 2-Phase 4 Wire/4-Phase 5 Wire Micro-Dc Stepper Motor Driver & 1 Set for Arduino Reduction Step Motor

1 pcs 5 Wire Micro-Dc Stepper Motor Driver & 1 set for Arduino Reduction Step Motor
Working e:1. Normal e 1: S1 start stop button, S2 forward and reverse button, W2 potentiometer speed control. If limit reversal is required, two limit switches can be connected to the P3 pin, and the motor motion shaft is mounted with contacts, so that the motor will reciprocate within the stroke between the two limit switches.
2. Normal e 2: S1 forwards the start button, S2 reverses the start button, press any button to stop. W2 potentiometer speed regulation. If the limit stop is required, two limit switches can be connected to the P3 pin, so that the motor will stop moving when it touches the limit switch, and the motor will reverse after the opposite button is clicked.
3. Jog e: S1 presses the forward rotation, releases the stop, S2 presses the reverse rotation, releases the stop, and the W2 potentiometer adjusts the speed. If a limit stop is required, the upper limit switch can be connected to P3.
4. Automatic Round-trip e: S1 starts and stops, S2 is reversed, W2 potentiometer speeds, and W1 potentiometer adjusts the automatic round-trip steps. After starting, the motor automatically runs back and forth within the number of steps adjusted by W1

Motor Driver Board:
Voltage Range: DC 5V-12V
Rated Current: Less than or equal to 800mA
Power Reverse Connection Protection: yes
Over-current Protection: yes
Overheat Protection: yes
Easy to use.
Long service life.
Color: green
Material: metal + PC
Driver Boards:
Stepper motor driver board with ULN2003 chip.
Four-phase LED indicates the status of the stepper motor work.
Stepper motor with a standard interface, when used directly pluggable.
5 line 4 phase can be driven by ordinary uln2003 chip, can also be connected in phase 2development board used for.
Supporting the use of a direct plug and easy to use stepper motor used in the development board.
Specification:
Rated voltage: DC 5V 4-phase
Step angle: 5.625 x 1/64
DC resistance: 200Ω±7% (25C)
Insulation resistance: Greater than 10MΩ (500V)
Dielectric strength: 600V AC / 1mA / 1s
Insulation grade: A
No-load pull in frequency: Greater than 600Hz
No-load pull out frequency: Greater than 1000Hz
Pull in torque: Greater than 34.3mN.m(120Hz)
Detent torque: Greater than 34.3mN.m
Temperature rise: Less than 40K(120Hz)
Noise: Less than 40dB (120Hz, No load, 10cm)
colour:blue
Material:ABS
size:10x6x3cm

Package Contents:
1 * Motor Driver Board
1 * DuPont line
5 * Driver Boards
5 * Stepper Motors

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1