1 Bộ Điều Khiển Tốc Độ Điện Tử Esc 30a & 1 Cái Mg90S 9g Servo Sg90

set2: 1 x steering gear + 1 x 30A ESC Brushed Speed Controller
1.[Full Metal Gear]Servos feel better than the cheap plastic geared servos. It is updated SG90 serve motor.
2.[Upgrades for RC & Robot]Using these in RC or a 3D printed robot arm you are working on., the metal gears help with the movement, these will rotate the proper direction.
3.[Light Weight] The servo weight is 13.6g, suit for RC Helicopter Airplane and small for Arduino Raspberry Pi project.
4.[Operating speed]0.11 seconds / 60 degrees (4.8V). The servo Maximum angle is 90 degrees in each direction. 5.Application Fields: remote control helicopters, mini robot, robot arm and boats. ALL kind of R/C Toys and for Arduino experiments
Compact and lightweight, easy to install and use
Designed for receiver and steering servo
Compatible battery: 2S Li-ion(7.4V) (not included)
Suitable for rc car or boat
Connector: short red (positive) and black (negative)------battery; long red and black(positive or negative is random)------motor; black red and white three-one line------ch2 of receiver
Material: ABS/Plastic + electronic components
color:black/Black + red
For Vehicle Type: Airplanes
Tool Supplies: Battery
Remote Control Peripherals/Devices: ESC
Function: forward, reverse, brake
Voltage: 4.8V---8.4V
Signal: PPM
Frequency: 2KHz
Output currents: 30A, 30 seconds 25A, 5 seconds 60A; 60A peak
UBEC output voltage: 5.7V
Size: approx. 90x 70x 5mm
Specification:
Size: 22.8mm(L) x 12.2mm(W) x 28.5mm(H)
Maximum angle: 90 degrees in each direction
Torsional moment: 2kg/cm
Working voltage: 4.8V
Operating speed: 0.11 seconds/ 60 degrees (4.8V) - The deadband setting: 5 μsec
Line Length: 300mm
Package Contents:
1 x steering gear
3 x damping rubber
3 x screw
1 x 30AESC Brushed Speed Controller
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1