GĂNG TAY DA HÀN TIG MIG MALLCOM D332

Găng tay da hàn TIG
Model D332
Xuất xứ: Mallcom/India
Găng tay được sản xuất trên dây chuyền hiện đại, Ấn độ được xem là thủ phủ của da bò.
Chất liệu da bò mềm và cực kỳ dày, giúp đôi tay thao tác mềm mại, tránh được các tia lửa hàn
Đạt tiêu chuẩn EN388 của châu Âu

DRIVER LEATHER GLOVES

4 tips yellow unlined driver gloves.

KEY FEATURES

Wing thumb with elasticised back.
Coloured tape binding.

DESIGN:

Yellow 4 tips grain driver glove.

PRODUCT MAKE :

Material : Grain leather

Cuff : Yellow grain leather cuff with elasticised back

Lining : None

Piping : Synthetic tape binding

SIZE: Universal 6 7 8 9 10 11

INDUSTRY / JOB: Manufacturing, Material Handling, Iron & Steel, Logistics & Transportation, Agriculture, Construction & Civil, Warehousing & Assembling, Repairs & Maintenance, Agriculture, Forestry & Horticulture

HAZARD / RISK: Abrasion, Puncture, Projectiles, Heat

PRODUCT WEIGHT: 1392 gms per dozen pair
( Weight of product may vary depending on customisations )

MINIMUM ORDER QUANTITY :
Custom : 10000 Pair

Ready Made : 60 Pairs

HOW TO USE
Instructions for storage: Store in a cool, dry place; away from frost and light in their original packaging.
Warning: Gloves not to be worn when there is a risk of entanglement by moving parts of machines.

TESTS CONDUCTED
Abrasion as per EN 388 is 2: Resistance to abrasion based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the gloves.
Cut as per EN 388 is 1: Blade cut resistance based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 5.
Tear as per EN 388 is 2: Tear resistances based on the amount of force required to tear the sample. The protection factor is then indicated on a scale from 1 to 4.
Puncture as per EN 388 is 2: Puncture resistances based on the amount of force required to pierce the sample with a standardly sized point. The protection factor is then indicated on a scale from 1 to 4.
TDM blade cut resistant as per EN 388 is X (X means not tested): The glove sample is placed on a conductive strip and loaded onto the TDM-100. When the metal blade touches the metal strip, the test is terminated. A straight blade is loaded into the machine. Weight is added to serve as a force. The blade moves across the fabric. The blade is replaced with a new one to ensure accuracy. The sample is cut five times, each with three different loads. The distance travelled to cause cut through at various forces is recorded. The data is used to determine the load required to cut through the sam