8 Channel Micro USB Relay Module Upper Computer 5V 10A Driver-free PC USB Control ICSE014A【COD / Low-cost Wholesale】
218.631
₫ 147.999
Sản phẩm 8 Channel Micro USB Relay Module Upper Computer 5V 10A Driver-free PC USB Control ICSE014A【COD / Low-cost Wholesale】 đang được mở bán với mức giá siêu tốt khi mua online, Vừa được giảm giá từ 218.631 xuống còn ₫ 147.999, giao hàng online trên toàn quốc với chi phí tiết kiệm nhất,0 đã được bán ra kể từ lúc chào bán lần cuối cùng.Trên đây là số liệu về sản phẩm chúng tôi thống kê và gửi đến bạn, hi vọng với những gợi ý ở trên giúp bạn mua sắm tốt hơn tại Pricespy Việt Nam
1.The module have MICRO USB and serial port , so they can communicate with PC and other device conveniently.
The normal working voltage for modules is 5V.And module of ICSE014A have a power interface of 5V. Parameters are as follows:
Interface
Modules all have Micro USB and serial port . Read following for details：
1.Micro USB: Standard micro USB mother mouth.
2.TX : Transmit
3.RX : Receive
4.5V : Volt current condenser
5.GND : Ground
6.Power Interface : Only ICSE014A have . Interface is used when Micro USB cannot give enough power.
Usage method
1.USB usage method
Module connect with PC through USB . The connection method is as follows:
Then open ”Relay Board Manager” to operate the module . Read ” RelayBoardManager_Reference” for details of the software.
2.Serial port usage method
Module can communicate with other device directly through serial port .
Module can receive single byte from upper monitor ( baud rate 9600)：
Upper Monitor 0x50 0x51
ICSE012A 0xAB
ICSE013A 0xAD
ICSE014A 0xAC
Module will turn to normal work state after receive “0x51” . Then every data byte will control the relay directly . Each bit controls a realy ( ‘0’ mark start , ‘1’ mark stop ) . Read following for details:
Package:
1 x MICRO USB 8-Kanal RELAY MODULE 5V 10A Driver-free PC USB Co
The normal working voltage for modules is 5V.And module of ICSE014A have a power interface of 5V. Parameters are as follows:
Interface
Modules all have Micro USB and serial port . Read following for details：
1.Micro USB: Standard micro USB mother mouth.
2.TX : Transmit
3.RX : Receive
4.5V : Volt current condenser
5.GND : Ground
6.Power Interface : Only ICSE014A have . Interface is used when Micro USB cannot give enough power.
Usage method
1.USB usage method
Module connect with PC through USB . The connection method is as follows:
Then open ”Relay Board Manager” to operate the module . Read ” RelayBoardManager_Reference” for details of the software.
2.Serial port usage method
Module can communicate with other device directly through serial port .
Module can receive single byte from upper monitor ( baud rate 9600)：
Upper Monitor 0x50 0x51
ICSE012A 0xAB
ICSE013A 0xAD
ICSE014A 0xAC
Module will turn to normal work state after receive “0x51” . Then every data byte will control the relay directly . Each bit controls a realy ( ‘0’ mark start , ‘1’ mark stop ) . Read following for details:
Package:
1 x MICRO USB 8-Kanal RELAY MODULE 5V 10A Driver-free PC USB Co