5 Bảng Mạch Điều Khiển Nano V3.0 Atmega328P Cho Arduino Nano & 1x 1.3 Inch Ssd1106 I2C 128x64 Oled

set2: 5 x Nano V3.0 ATMEGA328P ule Board + 1 x ule
What is OLED?
OLED (Organic Light-Emitting Diode) is a self light-emitting technology composed of a thin, multi-layered organic film placed between an anode and cathode. In contrast to LCD technology, OLED does not require a back light and therefore has much lower power usage. OLED possesses high application potential for virtually all types of displays and is regarded as the ultimate technology for the next generation of flat-panel displays.
Self-emitting light, does not need a back light High luminosity

CH340G Replace FT232RL
Micro-controller ATmega328P
Using Atmel Atmega328P-AU MCU, Support ISP download; Support USB download and Power.
Support for external 5V ~ 12V DC power supply;
Support power supply by 9V battery.
Lightweight and thin
Capable of wide viewing angles
Microcontroller Atmel ATmega328
Operating Voltage (logic level): 5V
Input Voltage (recommended): 7V ~ 12V
Input Voltage (limits): 6V ~ 20 V
Digital I/O Pins: 14 (of which 6 provide PWM output)
Analog Input Pins: 8
DC Current per I/O Pin: 40mA
Flash Memory: 32KB (ATmega328) (of which 2 KB used by bootloader)
SRAM: 2KB (ATmega328)
EEPROM: 1KB (ATmega328)
Clock Speed: 16MHz
Note:
This version is not included the USB cable.
Had change the USB chip, improve the download speed and stability of WIN7/WIN8
material: plastic/ccl
COLOR: blue
Low operating voltage and power consumption
Quick response
Wide range of operating temperatures (-40c to 85c)
Specification
Interface: I2C
Resolution: 128 x 64
Driver IC: SSD1106
Arduino Library: U8g2 library
Raspberry Pi Library: WiringPi
Wiring Pi Pin Description:
GND: Power Ground
VCC: Power + (DC 3.3 ~5v)
SCL: Clock Line
SDA: Data Line

Package Contents:
5 x Nano V3.0 ATMEGA328P ule Board
1 x ule

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1